View single post by cavanbound
 Posted: 05-21-2011 04:11 pm
PM Quote Reply Full Topic
cavanbound

 

Joined: 08-18-2010
Location: St. Cloud, MN, USA
Posts: 12
Status: 
Offline
 I looked through the postings and tech articles, and based on the tech article (http://www.jensenhealey.com/tech/dash/dashcap.html), I'm planning to pull my entire dash to get a proper fit and look for the dashcap I have from Delta.

I've not found any references to how many mounting points I need to pull for the entire dash to come loose (also, do I need to pull all the wiring and the oil pressure connection, or is there enough play in this if the dash is simply pulled loose?

Found this pic of the dash pulled from another JH (http://www.pjsmotorsports.com/?attachment_id=232), but cannot discern mounting points.  I've found the twin screws at right and left of the underside dash - I'm assuming there are other mount points in the mid-section?

Thanks for any pointers.