View single post by Brucesnows
 Posted: 02-20-2011 11:15 pm
PM Quote Reply Full Topic
Brucesnows

 

Joined: 02-13-2011
Location: Solana Beach, California USA
Posts: 6
Status: 
Offline
 I just replaced my 2 piece driveshaft (propshaft) when I was told that doing the suppert bearing replacement was a waist of time. So I had my local driveline shop make a new one piece with all new fittings and u-joints.

I installed the shaft and had some vibrations. It did not thump as before with the broken shaft bearing but I am a little concerned in lower gears with the vibration that I am experiencing???

Anyone have similar experiences with the 2 piece to one piece shaft conversion?

You should no longer need a suppert bearing???