 |
PM |  | |
Quote | | |
Reply | | |
Full Topic | |
| Joined: | 07-23-2005 |
| Location: | Franktown, Colorado USA |
| Posts: | 69 |
| Status: |
Offline
|
I posted this note earlier in the week under another topic it sounds like you may not have seen it. I checked the flywheels I have and I have two with the DA21785 stamped on them with 20H2 and 26L4 after respectively. I have two others with 7199397 cast in. Mine are all extremely dirty and hard to 100% confirm if the ring gears are machined into the casting or pressed on bit it looked, at first inspection without solvent cleaning them, that they have ring gears slipped on because of the machined outer surface and what looks like a slight groove where the ring gear would sit into.
Does anybody have insight as to why there are different casting numbers in the flywheels (DA21785 Vs. 7199397)?
Hope this helps.
Lash