| ||||
> Jensen Healey & Jensen GT Tech > Engine & Transmission |
| ||||
> Jensen Healey & Jensen GT Tech > Engine & Transmission |
| Moderator: Greg Fletcher | Page:   1 2 3 4 5 6 7 8 9 ...   |
 |
All Topics |  |
 |
Selected |  |
|
Popular | |
|
Recent | |
|
Mark Forum Read | |
 |
New Topic |  |
| Engine & Transmission - Jensen Healey & Jensen GT Tech - | ||||||
| Topic | Rating | Replies | Views | Started by | Last Post  |
|
|---|---|---|---|---|---|---|
 |
Changing rear differential gears Any difference between 4 and 5 speed rear axles? |
9 | 13,738 | Pricelessjunk | 03-10-2018 04:03 am by answerman |
|
|
 Damaged Cam Should I use this damaged cam |
5 | 8,727 | SimonD | 02-05-2018 10:25 pm by Esprit2 |
|
|
Another Delta performance exhaust question |
 |
3 | 8,646 | answerman | 02-04-2018 10:54 pm by allstateguy |
|
Transmission Leaks 4 Speed 13556 Help ! |
14 | 17,883 | stuartmorgan | 02-02-2018 01:00 am by Tim Murphy |
|
|
Compression Readings for 2.2L Stroker Lotus 907 Engine |
2 | 9,643 | Randallclary@icloud.com | 12-13-2017 10:48 pm by Esprit2 |
|
|
Reversed cams effects Redone head and free spinning engine. |
12 | 21,776 | tonyhawker | 12-12-2017 07:23 am by Esprit2 |
|
|
Engine rope rear main seal in early Mk1 Need to replace the rope seal |
7 | 11,998 | scottsmi | 12-12-2017 02:12 am by chrisl |
|
|
Speedometer Odometer vs speedo |
2 | 6,175 | jomac | 12-09-2017 02:03 pm by jomac |
|
|
Trans fluid |
3 | 8,221 | jomac | 12-03-2017 10:13 pm by Frank Schwartz |
|
|
5 speed trans Sticky shifts when cold |
2 | 5,799 | jomac | 10-12-2017 10:30 am by gmgiltd |
|
|
4 speed buzzes gears on Upshifts |
0 | 3,593 | Steve Duncan | 10-10-2017 06:06 pm by Steve Duncan |
|
|
replacing 4-speed speedo pinion gear |
6 | 10,349 | allstateguy | 09-30-2017 06:21 am by Jim Sohl sn 11210 |
|
|
oil pan |
11 | 20,488 | Davidsl95 | 09-30-2017 03:52 am by Esprit2 |
|
|
Differential Oil-GL-1, GL-4 or GL-5? Any Yellow Metals to worry about? |
10 | 15,192 | Steve Duncan | 09-28-2017 11:43 pm by Steve Duncan |
|
|
5 speed trans Speedo pinion gear |
1 | 4,687 | jomac | 09-17-2017 06:19 pm by NigelK |
|
|
Jensen Healey Specific - Eccentric Tensioner Hub Page: 1 2 3 |
46 | 64,036 | qwerty | 09-07-2017 07:48 pm by Bluekaos5 |
|
|
104 MOP cam gears. |
6 | 10,358 | buba1965 | 07-25-2017 04:51 pm by buba1965 |
|
|
907 Main Bearing Shells - Conversion to Run Chrysler 318 V8 Shells Lotus +0.015" Oversize Bearings No Longer Available |
7 | 11,678 | Esprit2 | 07-24-2017 01:31 pm by jcdean |
|
|
Oil Pressure too high Page: 1 2 Oil pressure gauge pegged at 100 |
23 | 35,779 | scottsmi | 06-21-2017 08:21 pm by Esprit2 |
|
|
cams, valve timing and ignition timing Page: 1 2 3 4 5 6 a little acedemic |
106 | 156,675 | fauxtog | 04-11-2017 07:25 pm by Esprit2 |
|
|
Cam belt replacement Page: 1 2 3 just replacing old |
43 | 80,087 | Joenpate56 | 04-10-2017 03:02 am by Esprit2 |
|
|
Judson Manning |
6 | 10,354 | Frank Schwartz | 02-28-2017 05:21 pm by Esprit2 |
|
|
Detailed & Annotated Engine Bay Diagram? |
2 | 6,813 | NJ_Brit | 02-22-2017 01:56 pm by NJ_Brit |
|
|
Speedo setup post W58 conversion Recalibrate speedo or swap out pinion gear? |
10 | 20,178 | NigelK | 02-12-2017 02:15 am by Esprit2 |
|
|
Low Compression on #1 cyl. |
5 | 9,915 | Paul Koehler | 02-05-2017 03:14 am by Bfitz241 |
|
|
oil cooler sandwich plate |
7 | 12,053 | Bfitz241 | 02-04-2017 02:15 am by Esprit2 |
|
|
Delta 4 into 1 header and steering column question Page: 1 2 |
|
20 | 33,883 | answerman | 01-21-2017 11:20 pm by Esprit2 |
|
renovated engine burning oil Page: 1 2 3 |
 |
46 | 74,585 | Barthol | 01-16-2017 11:21 pm by Esprit2 |
|
Getrag 5 speed transmission clutch pivot pin |
11 | 16,631 | little red | 12-17-2016 01:42 pm by little red |
|
|
New Rings? |
2 | 6,724 | Screenplay | 11-30-2016 11:11 pm by Screenplay |
|
|
oil cooler leak seeping |
6 | 10,542 | Bfitz241 | 11-29-2016 04:52 pm by gmgiltd |
|
|
Belt idler pulley and bearings. Page: 1 2 3 |
56 | 86,827 | Frank Schwartz | 11-29-2016 09:27 am by qwerty |
|
|
Heat from Transmission |
3 | 7,457 | sscheffel | 11-22-2016 02:59 pm by redracer |
|
|
Installing the intake manifold |
9 | 14,723 | Frank Schwartz | 11-19-2016 12:12 am by Jensen Healey |
|
|
5 speed Getrag install questions |
2 | 6,904 | Bob 13902 | 11-14-2016 01:04 am by jomac |
|
|
Shifting troubles Hard to shift into first and second |
3 | 8,313 | sjensen24 | 10-07-2016 05:43 pm by little red |
|
|
W58 Gearbox Reducing Noise Levels |
 |
5 | 20,633 | NigelK | 09-09-2016 01:19 am by atgparker |
|
Engine Flatlines At Random |
15 | 20,554 | NJ_Brit | 08-30-2016 05:40 pm by dwalls1 |
|
|
Rear end gear ratios 3:45 or 3:73 |
1 | 5,438 | Jetcat | 07-03-2016 08:35 am by NigelK |
|
|
Delta 4 into 1 header and steering shaft again |
4 | 8,440 | answerman | 06-17-2016 09:14 pm by Art DeKneef |
|
 Current time is 04:34 am |
|
Page: 1 2 3 4 5 6 7 8 9 ... |
||||
| > Jensen Healey & Jensen GT Tech > Engine & Transmission | Top | |||||
